Fiberglass Shower Pan Repaint Tips

Home and Kitchen Improvement

Blurring finishes, nasty buildup and the easy ravages of time can truly remove the luster from a fiberglass shower pan. The shower pan is repainting, a do-it-without anyone's help project for those with the painting background restores your shower to its previous greatness or gives everything new life with a splendid, intense color choice.

Evacuate any exhausted caulk around the edge of the shower pan. Apply a caulk remover to qualify it. Slice the caulk among a utility knife. Uncover stubborn pieces with needle nose pliers or a putty knife. Clean the once caulked areas with an isopropyl liquor and a build-up free cloth.

Wear breathing assurance and sand the whole area of the fiberglass shower pan with 320-grit sandpaper. Sand softly – stop sanding during the shower pans finish becomes dull. Evacuate excess dust with a wet-dry vacuum and tack cloth.

Furnish yourself with elastic gloves, work goggles, and respiratory insurance. Ventilate the territory as best you can, smashing any windows and turning on adjacent fans.

Include a couple of capfuls of muriatic corrosive – available at home remodeling centers and pool equipment stores – to a pail brimming with warm water. Plunge a scrubbing brush into the can and scrub the whole area of the shower pan with the corrosive solution. Rinse the shower altogether and enable it to air dry perfectly.

Tape off the edge of the shower pan with painters tape to avoid overspray spots.

Fill your paint sprayer with a small area of epoxy primer for a test. If the primer sprays on to the test board uniformly, continue with taking action pan. If it does not, expand it with epoxy paint thinner continuously it sprays easily. Begin spraying at a low pressure setting and raise the pressure setting continuously you accomplish uniform inclusion.

Apply the primer to the fiberglass shower pan with the spray firearm. Hold the firearm around 12 inches from the area. Keep the ways consistent and the sprayer in movement. Make slow, even strokes. Cover the edge of the previous stroke for each new stroke. Enable the primer to dry fully according to the manufacturers directions.

Rehash the experiment and application method with an epoxy-based paint in the color of your favorite. Enable the paint to dry according to the manufacturers directions and apply extra coats to your taste. Give the paint a chance to set for 72 hours. Remove the painters tape.

Reapply caulk using a caulk firearm and tub and tile caulk with fungicide. Enable the caulk to dry completely as stated by to the manufacturers ways previously using the shower.

Things To Need

    • Caulk Remover
    • Utility knife
    • Putty knife
    • Isopropyl liquor
    • Needle-nose pliers
    • Build up free cloth
    • Wet dry vacuum
    • Tack cloth
    • Masking tape or painters tape
    • Respiratory security
    • 320 grit sandpaper
    • Elastic gloves
    • Elastic gloves
    • Pail
    • Work goggles
    • Scrubbing brush
    • Muriatic corrosive
    • Paint sprayer
    • Epoxy paint thinner (optional)
    • Epoxy primer
    • Epoxy based paint
    • Tub and tile caulk (with fungicide)
    • Test board
    • Epoxy paint thinner (optional)
    • Caulk weapon

Tip

Pursue any directions or warnings on the muriatic corrosives name. Wear long clothes to avoid contact with your skin.

Read More:

Leaky Shower Pan? These Tips Will Help You Out